Command For Arp Local Proxy

6.5 Command for ARP Local Proxy

6.5.1 ip local proxy-arp

Command: ip local proxy-arp
no ip local proxy-arp
Function: Enable/disable the local ARP Proxy function for a specified interface.
Parameters: None.
Command mode: Interface VLAN Mode
Default: This function is disabled on all interfaces.
User guide: This function differs from the original proxy-arp because it acts as an ARP Proxy inside the same layer-3 interface. This function directs the layer-3 forwarding of the switch.
Example: Enable the local ARP Proxy function of the interface VLAN1.

active500EM(config-if-vlan1)#ip local proxy-arp

 


Return to Controller Wired CLI Table of Contents